Is simpler better?


I have been adding components in my audio systems and subtracting as well at times. Over some time now, I wondered if I hear better resolution, dynamics, clarity and get closer to the recorded music when I keep the path short and simple. I mean one source, one integrated amp and to the speakers. Or even a digital component to a DAC then to the integrated amp and finally to speakers. Bypassing the preamp or in some cases bypassing a separate DAC. It certainly elimates the need for redundant volume or gain, reducing wires or cables, reducing the chance for incompatible components and keeping the path short.

For those using turntable(s), does the combination of phono preamp, platter, tonearm, cartridge, motor, isolation get to be too much to manage? To get the best sound? 

Your thoughts? Your experience?

128x128Ag insider logo xs@2x2psyop

Einstein said it best, “everything should be as simple as possible, but no simpler.”

 

For me, a preamplifier is vital. Not only does it serve as my "switch" for different sources (analog vs. digital sources) but it provides a small amount of gain and, aside from the speakers, does the most to define the sound of the system. The wrong pre can make your system sound flat or thin or too chunky. 

While I agree at more cable is the enemy I think that in every situation trade offs must be made. For me, Monoblocks amplifiers allow me to have very short runs of speaker cable, only about 3 feet. I'm willing to have longer interconnects as my experience has shown longer interconnect where the signal is low gain, does less damage to the sound than long speaker cables where the signal is highly amplified. The interconnects between my other comments are very short. 

I'd also encourage you to think about the fact that while sure, the wire connecting one component to another light be longer than one on the inside of an integrated or more complex component, it's almost always better shielded and of higher quality wire.

Food for thought.