Isolation Feet for Laptop

It seems fairly common knowledge that vibration is a form of distortion in many electric components, not just for turntables and speakers. Isolation feet seem to work well in most applications.

I searched around and I didn't find any information to suggest that folks are using isolation feet on laptops or desktops, despite increased streaming usage. In a great many cases, there are indeed heavy vibrations coming from within the computer.  Whether it is the fan for the CPU or even GPU to the all the various chips/transformers, etc or even power supplies and batteries. If adding isolation feet to a streamer, DAC or power supply makes sense, then wouldn't it also make sense to apply isolation feet to your laptop; if you use it for music?

Well, I am going to find out. :)

I ordered some IsoAcoustics Orea Series Audio Equipment Isolators with a max weight of 16 pounds. The laptop weighs about 6.7 pounds, so it shouldn't be that much strain, even with all the cables creating some measure of down force as they dangle over the edge.

My expectation is that the DAC will be able to perform slightly better due to reduced vibration across the USB port and power filter. The DAC is a USB stick (Dragonfly Cobalt) so it has a very rigid hard connection to the laptop; so vibration is very easily transferred.

Has anyone else tried this?



I don't use power savers. No screen savers.  The system is in presentation mode.  It never saves power.  Unless I disconnect the plug.  On battery, it will conserve power. IN which case, all performance goes downhill.

You missed several possible steps, revisit what leg of your power panel all the digital stuff is on… 

electrical sleeve heatshrink 



Sorry I am still not sure we’re on the same page with terminology.

The power panel to the house cannot be altered by me, since I am renting.

The Shunyata Venom V16 has two zones. The monitor and laptop are plugged into Zone 2 and the speakers and sub are on Zone 1. They are separated from each other following Shunyata’s CCI tech. Also, both the monitor and laptop use their digital cable, which has noise filtration built into the IEC NEMA connector.

Looking briefly into electrical heat shrink, this appears to be the rubber used to seal electrical wires when you're either splicing, splitting, or attaching connectors.  I have some of this.  Are you suggesting I put a sleeve over the laptop's electrical plug (that goes into the laptop) to stop any possible EMI leak?