KT120 Tube compatibility w/ Jadis Defy 7 Amp MK 1


Hi, I have an original Jadis Defy I just acquired for I liked its sound very much. However, I don't have any users manual or schematic for the serial #445. Could anyone help by sending a .pdf or electronic copy.

Also, there is a new tube out for the KT88/6550/KT90/EL34 socket line called the KT120. It is the most powerful tube of all of them.

I would like to replace all of the current (12) 6550B tubes with the new larger KT-120 Tubes by Tung Sol (which has a plate dissipation of 60 watts, making it the most powerful tube in the 6550/KT88/KT90 family, or approximately 10 more watts/tube vs. KT90 . Also, when used at the parameters found in existing 6550/KT88/KT90 circuits, the Tung-Sol KT120 is impervious to overload, delivering peak power with extreme reliability and long tube life). Another note regarding universal replacement/compatibility is that the glass envelope of the KT-120 tube is 1/2" taller than other KT88 cousins to accommodate the larger internal plate structure and larger control grid cooling fins, which won't present a problem. However, a word of caution is given regarding the KT120's small increase in current vs. the next most powerful KT88 or KT90 (close in current draw), wherein they say the filament of this tube draws 1.7A to 1.95A, or 0.1 Amp to 0.35 Amp (100 to 350 mA) more current than a KT88 at 1.6 amp; so they say to be safe and recommended to check with your amp manufacturer to make sure the Jadis Defy 7 filament transformer will or can handle the increase in current (at 0.1 to 0 .35A/tube and if you have a quad that is 0.4-1.4A total additional current draw with normal current of 1.6A/tube) without any transformer mods. Will this small increase in current for the Jadis Defy 7 filament transformer be able to handle this increase draw in current required of the Tung-Sol JT120?

Any help answering this technical question would be greatly appreciated and I would gladly pay for a owners manual/schematic for this 100wpc push-pull configured amp design.
bradleys
Not owning a Defy 7 in some time due to upkeep and retubing cost,two things I can say without hesitation.Dont substitute those tubes and forget about any customer sevice!!!
I've contacted my friend at the company in regards to the question in this thread. Hopefully, he gets back to me with the answer soon after the weekend is over. I also invited him to post here directly.
Heard back from my friend at Jadis.

KT120 tubes present no problem at all in the Defy DA7. Only rebiasing is necessary.
Thanks all. If the 120's are used, what is biasing set at since a lower setting will offset any transformer demand increase?; lower than the normal 4 volts of course, so what would be optimal Trelja?

Doc
Doc, my experience with Jadis biasing is that when they say "rebias", it is always to the same spec (in the case of my JOR 90 - 120 mv, 110 being the ideal value), regardless of the different (or, even same - EL34, 6CA7, KT77, 6550, KT88, KT90) types of tubes used. My other two Jadis amps are cathode bias, and are "plug and play" when it comes to (a pretty wide range of) output tubes.

They are very cautious to ALWAYS tell you to rebias in their products that have such adjustment. I'm not sure of the Defy DA7 values, but I'm working under the presumption that you have them.