Linlai E 6sn7 tubes


I just placed an order for a pair of these for my Aric Audio Motherlode II.  I’ve been chatting with a fellow that runs the E 6sn7 in his Don Sachs pre. He loves them, He says they make his NOS tubes sound thin and lifeless.  
    It will be a couple weeks until I receive them,and I was curious if anyone out in Agon land has tried these,and what are your impressions?   
Thanks in advance,

    Ray

128x128rocray

Maybe 1hr isn’t enough? Maybe they have to burn in a little?

I'll still give them a try, & record the hrs. I put on them.

Running the LinLia E-6SN7's in my Aric Audio 6SN7 line stage. Feeding my Aric Audio Super KT88 120SE, the one pictured on his website! I will be buying a second set for the amp.

I have accumulated a very good selection of NOS 6SN7 tubes. The LinLia 6SN7's while aren't perfect they give me the balance of my favorite NOS tube qualities. In my system they have the detail of the Sylvania's but not quite the high end extension. The midrange beauty of the RCA's. The low end I find a lot like the Westinghouse and a tonal quality like the GE glow domes. They just do it with such a large but intimate soundstage. Its as if the globe shape also represents the soundstage.

 They just managed to balance a lot of my favorite qualities. I will be buying more!

That's my ramble!

J.F.

After reading this entire thread, I’ve decided to order a set Linlai E-6sn7. I recently purchased a SLP-98; can anyone tell me, if 4 will fit?

At 100 hours the Linlai 6SN7 sound about the same, perhaps a little more open with tighter bass. I could live with this sound, without further improvement. I would take a little more midrange warmth and ambiance. But, they sound really nice at this point. 

Thanks,

aldnorab

@coachpoconnor If it fits, I bet it will be tight in the ’98 and pins possibly not fully seated to the base. Also, may depend on which Linlai you buy. Some are narrower at the lower hip area. Here is a photo of the Psvane 181-TIIs, and they are wide and bulge out at the bottom. I was able to make the top psv work in my SLP-98 yet they could sit down more if the cutouts the top plate of the preamp was a wider diameter. The 2nd Linlai tube pictured here is narrower at the lower hip, might fit better. The bottom linlai tube pictured here is wider hip like my psv is and might be a tight fit or bottom out on the top plate before fully seated in your 98. Best of luck.

CV181-TII (wide lower hip)

New Linlai 6SN7 Hifi Black Plates, Gold Pins, shouldered (slightly more narrow hip)

New Linlai E-6SN7 Globe-Balloon Black Plates (wider lower hip)