Kind of confusing, but here it is...
BE SURE THE SPEAKER JUMPERS ARE REMOVED and all power is off. You can short your amps if not
-Remove speaker jumpers
-Each wire on the K400 should have a connector (4 left/4 right)Your left set of K400 wires will transport the treble down one half(pair +/-) and the bass down the other half(pair+/-) to your left Tukan. The right set of k400 will carry the treble/bass to signal to the right Tukan
-Remove the pre-amp jumper on the Majik
-Install L/R rca interconnect from "pre out" to "input" L/R on the LK85
-Connect the L/R speaker treble +/- to the LK85 (top connection on the rear of your Tuks
-Connect a L/R pair of RCA interconnects from the "out" on the rear of the LK85. Run this "back" to the rear of the Majik and connect at the "amp input" (the remaining side where the pre-amp jumper was removed)
-Connect your bass speaker wire L/R for each Tukan from the Majik to the lower L/R inputs on each Tukan
Your low level L/R now comes out of the Majik into the LK85 to power your tweeters L/R, it daisy chains back low level L/R from the outputs on the LK85 back to the Majik amp section to power you woofers L/R.
You now have a separate amp powering the L tweeter, a separate amp for your R tweeter, a separate amp for the L woofer and a separate amp for the R woofer, each being supplied by it's own set of speaker wires +/-.
You are now "bi-amped" correctly.
Hope this helps
Dan
dedicated audio
BE SURE THE SPEAKER JUMPERS ARE REMOVED and all power is off. You can short your amps if not
-Remove speaker jumpers
-Each wire on the K400 should have a connector (4 left/4 right)Your left set of K400 wires will transport the treble down one half(pair +/-) and the bass down the other half(pair+/-) to your left Tukan. The right set of k400 will carry the treble/bass to signal to the right Tukan
-Remove the pre-amp jumper on the Majik
-Install L/R rca interconnect from "pre out" to "input" L/R on the LK85
-Connect the L/R speaker treble +/- to the LK85 (top connection on the rear of your Tuks
-Connect a L/R pair of RCA interconnects from the "out" on the rear of the LK85. Run this "back" to the rear of the Majik and connect at the "amp input" (the remaining side where the pre-amp jumper was removed)
-Connect your bass speaker wire L/R for each Tukan from the Majik to the lower L/R inputs on each Tukan
Your low level L/R now comes out of the Majik into the LK85 to power your tweeters L/R, it daisy chains back low level L/R from the outputs on the LK85 back to the Majik amp section to power you woofers L/R.
You now have a separate amp powering the L tweeter, a separate amp for your R tweeter, a separate amp for the L woofer and a separate amp for the R woofer, each being supplied by it's own set of speaker wires +/-.
You are now "bi-amped" correctly.
Hope this helps
Dan
dedicated audio