LTA - MZ2 Driving solid state amps.


Hello All,

I want to get a new pre and I have narrowed it down to the LTA  MZ2 and ps audio bhk, with the mz2'being the one I probably will try.Both of these have built in headphone amps which I would occasionally like.

I would like any feedback on both preamps related to the pairing with solid state amps of any kind.

Kenny.
kdude66
Nick,

You might check out the thread titled,
https://forum.audiogon.com/discussions/initial-impression-of-the-nuprime-st-10-amp

Both the St-10 and the S-500 are really good examples of modern class d amps without breaking the bank.

That's a bummer to hear about the la show,I don't go to them anymore they are just not enjoyable to me.

I seriously considered the spatials and the pure audio project with the voxative full range driver but in our new smaller house I really don't have the correct room for them or panel speakers either.
But that's ok I really like my DI's.

When do you think you will get your MZ2,mine is supposed to be shipped by the end of next week.
I can't wait.

Best,

Kenny.


Thanks for the link Kenny.  I'll add the S-500 to review too.  I expect to receive my MZ2 by June 23rd.   Should be getting the speakers about the same time.  Can't wait!

Nick
Hello all,

Finally a MZ2 has arrived in my system,I'm using the tubes that were shipped with it for now,RCA 12sn7 and Ge 6201's.

This is most definitely going to be a game changer for me,I really don't want to turn it off and change tubes,maybe tomorrow.

I'm using the speaker outputs to pwr my 95db Tekton DI's.
Kdude66,
                I completely understand.  I hated to give up the demo I was using prior to getting my MZ2.  Wait until you put in NOS tubes! Remember that the power cord also makes a big difference!
Bob