Lyra Titan i with a Manley Steelhead....settings??

You should continue to experiment. I have the Steelhead and have used a Titan i as well as the Airtight. The Titan is extremely VTA sensitive, compared to the Airtight. I also had better success using the MM inputs, setting @ 100 if memory serves. Of course, I am using horns and certainly didn't need the added brightness that I seemed to get via the MC inputs. Parts of the spectrum seemed very alive, but the MC input also seemed to create an unevenness in the spectrum, top to bottom, with certain frequencies brightly lit, and quite airy, and others rather attenuated. Maybe I was hearing ringing, or some kind of mismatch, but I spent a fair amount of time horsing around with it. The Airtight sounds far less spotlit than the Lyra, but very musical. Enjoy. BTW, NOS tubes seem to make a big difference in the Steelhead, if you really want to play around with it.

I agree with Whart about the extreme VTA sensitivity of the Titan. A change of as little as .3mm of height at the armpost (Vector arm, which is 9" in length), makes a substantial change in the sound.

JBatlanta, as you have noted, going to a higher numerical value of resistance in the loading (which actually DECREASES loading because it is in parallel), causes the bass to thin out. You would get a similar result by increasing VTA (raising the armpost of the tonearm). Thus, the two adjustments have a similar, but not identical impact on sound. This means that if your VTA is too high, you could sort of compensate by choosing a lower value loading; this would sound okay, but not ideal. I think it might be worthwhile to change VTA and then reset your loading by ear to determine whether you can get even better results.

The 25 ohm value you settled on seems to be low (a lot of loading), based on my experience and that of another Titan owner. Our phono stages are different, though we both use tube stages with a step up transformer at the front end. It could be the right setting in your setup, but it could also be compensating for too high VTA. That is why I suggest experimenting with lowering your arm just a bit, and then seeing if a different loading would get you to an even better result.

Have fun.

Larryi,

~ how may turns on the VTA dial = .3mm change? I have a Vector Mk3 and a Lyra Titan i on a 2800.

Thanks
Rich

Rmaurin,

I don't have the VTA adjustment mechanism. I have made a set of spacers out of 1/2" PVC pipe that have been filed down to different heights. The spacers differ in height by .3 mm (measured on a set of calipers). This difference is easy to hear. Perhaps one could discern an even smaller increment, but, I would have to make a ridiculous number of spacers.

You obviously have a much easier time making changes with the VTA guage. This is a big plus with the Titan. I don't know if the Titan is particularly sensitive or whether one easily hears the change because the top end of that cartridge is so clear, detailed and extended.