Mains Power Cable DIY

Pindac and all,

I know this is an older thread, but wanted to see if any of you are still around on this subject. I went a little "manic" and bought a ton of high quality cable to build my own DIY power cables. I have: Neotech NEP 3002 and 3003 UPOCC, Furutech FP-OS32 "Alpha nano", Furutech TCS031 Triple C, Furutech FP-S55N "Alpha nano", Oyaide Tunami 102 SSC, Acoustic Revive 8800 Triple C, and Monosaudio 902 and 903 OFC cables.

For connectors I've got Viborg VF-502 and VF-508 silver plated, Sonarquest P-25/C-25, IeGO 8065 silver plate and 8085 gold plate, and Furutech F-11 and F-28 gold plated.

The problem that I created (even though they are first world problems) is that I really do not know where to start as far and connector and cable matching. Second I have seen two ways of connecting the cables to the connectors: one is using the bare wire and then using a spade such as the FP-209 (gold or rhodium) at the end of the cable and connecting that to the power connectors.

Furutech's own website and videos show using the FP-209 rhodium as the intermediate step and use those to connect to the power connectors.

Any help here would be much appreciated, as these are my first power cables I'm DIYing.....but I do have the proper crimping and soldering tools and experience.

@vthokie83 Thank You for the request.

Typically Swapping out Wall Socket Connectors and IEC's on a Cable is reasonably straight forward.

A Multimeter will enable continuity testing of Wires once terminated.

The last time I produced a Cable I discarded the Spades, as I was having continuity issues, when terminating.

As for Metal used in a Plug Connector, Pure Copper without Plating is the preferred, but that is based on Copper Wire > Copper Terminations. I have not Annaly been checking Brass with a Coating or Copper with a Coating, so am not able to comment.

My experiences to date is that Digital and SS will benefit the most, in relation to discernable changes to the end sound being discovered and 50+ Hours of usage will have a different Cable in use that one with a few hours.

If a device with little value has an IEC, this can be used to assist with increasing the hours of usage.  

Not to sell you short and also a method that might need for you to Talk to a Electrician or a Forum Member with savvy.

The connectors in the link are Pure Copper and removes contact pins in the routing of Power Cables into Plug Sockets.

This is the method I am at present most likely to adopt.

I am at present working my way through the issues and alternative options where there will be removal of Fuses.

I take professional guidance on all Matters Electrical and Electronical.

https://www.wago.com/us/certificates#:~:text=Not%20only%20is%20WAGO%20qualified,approved%20according%20to%20strict%20standards.