Mark Levinson / Voltage Conversion US = Europe


Hi folks. Probably this question was already asked once before in these threads, however I could not find anything so far.

My situation: I am living in the US right now and would like to get a 326 / 431 / 390s. At some point of time (one year or so) my contract will end and I might go back to Germany.

I can not afford to get these components new, so I would buy them used in good condition, which is still a good junk of money.

However before I make this relatively big investment I wanted to know following: Is there someone someone who would professionally convert the components from US voltage to European (German) standard. It does not matter if here in the US or in Germany or in Europe.

So, to get an answer to my question I called the customer support at harman/madrigal in the US and they told me technically this would not be an issue, but they do this only for the original owner and only if you have proof of leaving the US. Apparently "just" a power-supply-platine and the back-cover would have to be changed.
For pre-owned components they referred me to the importer in Germany to check with them if they would do it. So, I called them (Sun Audio in Munich) and they told me that they will not do it either because of TUeV and CE reasons, which I think is complete BS.

Sure, I can understand that they are trying to protect their overseas market, but I look at it from this side: Every used model which is sold, creates a demand for a new one. Like I said this would only work for me, because prices are lower here, and there is no way for me to afford these components overseas.

My question now: Does anyone have experience with a conversion from US to European voltage? Who / Where / How long / How much / What to do / What not to do / etc.

Please let me know.
Thank you for your response in advance.
herrlich
there is a module you can buy from levinson to change someof the units to 240v but after you reboot you need to enter a code for it to work.

the french concessionaire is happy to make the conversion on non new models for a reasonable price
I can say with 100% confidence that under the metal shielding inside the 326, you can place a jumper to set the voltage from anything between 110 and 240 Volt 50 and 60Hz.
So you do not need a dealer or anyone else to assist you.
I am almost sure you can do the same with the 436.
As for the 390 I do not know, but I would be very surprised if it would be different from the other two.
326S is protected by an electronic circuit, as soon as the voltage is altered, you can no longer use the unit unless a Pass Code is entered. Not all European ML distributor is willing to support/provide this code.

Not sure if ML does that to the power amp.
I have found no evidence whatsoever that the 326S or the 320S has any electronic circuit to sense the mains voltage.
You can simply change a jumper for a different mains voltage.

I know what I am talking about because I took the preamp apart, and analysed the whole thing in detail and documented every circuit.

Those kind of horrifying stories are just invented by those who want to prevent cross border selling.
You simply should not believe all nonsense that is being told.
T024484 - did you try to run it from 230V / 50Hz mains ? I'm asking since my Krell KRC-3 amp also "looked" to be easy to convert (there are 3 switches inside that change the voltage), but after setting them to 230V the amp would not start from stand-by. I had to replace the chip inside the amp to make it work.