Micromega M-100/150 field reports

I did notice big improvement over lower end DAC from Schiit after I plugged in hiface 2, M2tech do make some reputable products and it's Italian company specialized in DDCs, and DACs. My toddler broke my hiface 2 before I can sit down and have serious A/B session, therefore I'm stuck with USB direct to M100 for now. Maybe my mind is playing a trick on me but I felt USB direct to M100 for some reason doesn't sound as alive and detailed compared to Hiface 2 to Coaxial. Anyhow, I'm looking into Audiophilleo 2 with pure power make sure keep it away from my toddler this time. 

Quick update after few months with M100, I've added Isoacoustics newest Orea Bronze feets (3) under M100, and Gustard DDC-U16 between MacBook Pro and M100 via I2S input. Source is MacBook Pro with Tidal Hifi from Audirvana 3.5. @usery, you are right, M100/M50 sounds great no matter what input, however with a good USB Converter for my setup just gave that little extra push. The sound stage is deepen, a bit more 3 dimensional, and added micro details still amazes me each every listening session. 

I realize this thread is a little out of date, but hoping the previous contributors might be able to respond.  I just got my M100 back from repair where it apparently had an “intermittent fuse case holder”, and bad “varistors”.  Anyway, seems fine now.  
On to my question.  I’ve downloaded the app for iOS.  I’ve never connected it successfully to my m100.  The app always says “make sure your devices and smart phone are connected to the same network”

do I need to connect the m100 to WiFi?  I’ve not been able to figure out how I might do that. Seems others have connected no problem.  Do I need a LAN connection to my home network for that to work?

Thanks for any help you can provide.

s7horton said:

"I’ve downloaded the app for iOS. I’ve never connected it successfully to my m100. The app always says “make sure your devices and smart phone are connected to the same network”

Did you reflash the M100 network firmware after the repair? If not do that - see the user manual for instructions (easy).

"do I need to connect the m100 to WiFi? I’ve not been able to figure out how I might do that. Seems others have connected no problem. Do I need a LAN connection to my home network for that to work?"

Yes you need a LAN connection - the M100 only has a RJ45-type network interface (ie wired), no built-in wifi support. So you need either a ethernet cable run from your main router to the M100, or a wifi router/extender bridged from your main router then a short ethernet cable to the M100. The former is waay preferable if your house layout allows it.

Thanks for the response.  The simple solution is for me to connect an extender via Ethernet.  I’ll give that a try tomorrow.