Ted, thanks for joining in. I did in fact at one point try hardwiring, and removed the small PC board and hardwired my IXYS diodes and Panasonic FM Cap to the secondary windings in an early modified version, but because of larger physical size and the radial leads of the components I use, simply could not comfortably fit inside the MPC enclosure. Even so, I heard minimal if any improvement. I have simply never heard great improvement in hardwiring power supplies as you have described, especially when dealing with such a small 1.5 inch by 1 inch sized PC board with only a few solder points.
I HAVE however heard tremendous improvement when one hardwires SIGNAL carrying wires, such as hardwiring loudspeaker crossovers, interconnect cables inside components avoiding chassis mount RCA connectors, and hardwiring loudspeaker cables to avoid using binding posts, etc. Your brilliant ITF Bi-Wire idea would fall into this signal carrying hardwire category, eliminating a connector and solder connection. Thanks, Michael Spallone