Modding Synergistic Research MPC to Galileo status

I recently had the good fortune of upgrading my stock Synergistic Research MPCs closer to Galileo Status by the help of a friend who is inclined to do such work.

He replaces the Synergistic MPC's four cheap, general purpose 1 amp rectifier diodes with four ultra fast, soft recovery IXYS rectifier diodes and the 470uf 50 volt dirt cheap chinese electrolytic cap with a 680uf Panasonic FM extremely low impedance, high ripple current, long life (7000 hrs). It is now a super low noise power supply.

This mod provides better shielding to Synergistic Research cables resulting in more transparency, blacker backgrounds, increased detail and warmth with even lower noise floor than stock MPCs.

I was really taken aback by the improvements mentioned above. When considering the cost of a Galileo MPC, this mod is a downright bargain.

The cost of this mod will be $40-50. I can provide contact information for additional questions regarding components and price.
The Michaelspallone mod is sounding so wonderful on my Tesla T2 SE, so far ahead of the stock MPC it's ridiculous. I'm awaiting arrival of an Element Tungsten SE and can't wait to put the modded MPC on it. I can't believe it's going to get even better than what I'm hearing now.
Very cost effictive upgrade to your original mpc's.Everything that was there with the stock ones is now if you will more enhanced in every area.Soundstage,depth,cleaner highs,better bottom end.In my opinion all this due to an improved noise floor.Once again my thanks to Michael for such an outstanding job.
I took a flyer on Michael's mod for the MPC attached to the Tranquility Basik platform. At the price I wouldn't be bothered if the mod didn't work as well for this application as it did for cables. I was pleasantly surprised by the increase in transparency and air so had the 2 MPCs for my Hologram A and D power cables modded to the same result combined with more "you are there" to the sonic picture. Thanks to Ted for designing such innovative products and to Michael for taking one of them to a higher level at a reasonable price.
I would like to apologize to the community for any confusion as to who the OP was on this thread. It was I, Devilboy, not MichaelSpallone. I contacted Audiogon asking why and how this could have happened and expressing concern as to members being confused about who wrote the post. Basically, they said it was a "glitch", explaining that it must have happened while I had a "cookie" opened in the system while communicating with Michael via email. Frankly it's all a little too bizarre. So everyone, I would like to apologize once more for Audiogon's mistake and also for any confusion this may have caused.
Michael did the mod to my T3 MPC connected to a tube power amp. Lower noise floor, much better highs and less glare. I can't say if it's equal to the Galileo but don't have any desire to compare them now.