Mods - Odds and Sods???

Sean, thanks for your perspective. It is definitely appreciated, coming from someone who has seen this for real. Anyway, you are so right about swapping parts as opposed to actually modifying a component.

In the situation I was alluding to, the component was "modded" in that the coupling caps were upgraded in these amplifiers. However, the number one issue the NEEDED to be corrected in this product was the fact that the power cabling is bundled with a lot of the other wiring in the amp. Sure, it makes for a cleaner presentation, and probably easier manufacturing, but the difference addressing the cable routing inside these amps overshadows a capacitor upgrade by several orders of magnitude.

My friend is a thorough modifier of equipment, as opposed to someone out to pad their bottom line, because he realized that this free tweak was the most effective and critical improvement that he could make. Over the phone, he wouldn't tell me what this "crime" was, as he wanted to surprise me in person. Of course, he also upgraded the coupling caps, as well as the binding posts, input jack, and tubes. When I asked him what kind of performance gains his changes had wrought, he had no idea, as he never listened to the amps stock. In his opinion, there was just no point.

The thing is with the items for auction here, upgrading a part enabled the seller to fetch 75% more for the used item than what it listed for new. Interesting

Joe: I went through an identical situation with some of my equipment. That is, i opened up a pair of large high bias monoblocks ( 250 / 500 / 800 wpc ) and found signal cables bundled together with power cables. Needless to say, i started re-arranging things and ended up with over four feet of wire being pulled out of each amp. Not only was the signal path WAY shorter, the whole installation was MUCH cleaner too. The funny thing is that the entire audio path was wired with Cardas cabling from the factory, which meant that the manufacturer was throwing money away by using such a backwards approach to assembly.

I think that if more people knew how poorly their gear was designed and assembled, there would be a lot fewer "audiophile approved" companies in business. Like i said, it's not "sabotage" so much as "idiocy" and lack of engineering / understanding. Sean
>

This is an interesting topic, really, because I've been doing quite a few modifications to tuners recently. Nothing terribly substantial really, but tuners are nice to do because the mods and alignment are both audible AND measurable in a very significant manner. As to manufacturers intentionally designing bad products: I have to wonder if this is true. I'll relate a case in point:

I just did a modification to a Magnum Dynalab FT-101A which was possibly three or four years old. The first thing I noticed was that the ceramic IF filters were types completely unsuited to high fidelity. A simple swap dropped THD from .2% to .03%, which is just a shocking amount without even a real circuit change. Even better, IM distortion dropped 20dB! This was also the only tuner I have ever seen without a channel separation adjustment, and as a result, the separation is over 20dB worse than most other tuners. So you have to wonder just how bad the engineering here is. Using different filters would cost the factory basically nothing.

They also used cheap electrolytic caps on the outputs (although there are spots on the board for the film caps used in the Etude, for which they charged an extra $500), which the customer wanted replaced with Black Gates. When I pulled the circuit board to replace them, I noticed bare traces on the board in a number of spots, a lot of white powdery oxidation, and some traces that had fallen right off the board, primarily in the ground plane. This unit looked pretty pristine, so I really can't explain that either.

So, there's one more example of poor engineering and construction to tack to the list, I suppose. Interesting topic. Has anyone else pulled an audiophile component apart and found things that just shouldn't be there?