Monoblock setup inquiry


Hey, 

So I'm somewhat of a newbie, but I've taken the plunge down the rabbit hole and have almost completed my system.  I'm running source(mix of vinyl and tidal)--> DAC/Phono--> Freya+--> Aegir--> Kef R3.  Currently I'm running one Aegir which is slightly underpowered for the R3's, but I have another Aegir on the way and I'm planning to run them as mono blocks. 

I've done quite a bit of research on how to set them up and can't seem to find a straightforward answer.  It seems that there's a couple different methods..Horizontal vs. vertical and bi-amping vs bi wiring.  To be honest I think I'd be ok with the simplest setup.  I'd like to dedicate one amp to Right channel and one to the left, and bi-wire if it will improve performance.  

So I have a couple questions..

1. From Pre-amp to amp do I simply connect 1 single Rca from Right output into R input on the amp to the right channel and same for the left? Or should I use both red and white cables to the Amp for the right and both for amp to left channel as my preamp has 2 RCA outs(a total of 4 connects 2 white 2 red)?
(Ive included a link with pics of amp preamp and speakers for clarity)

2. I understand that If I want to use the amps as simple mono blocks I should connect speaker wires to the top 2 red terminals on each amp and connect to speaker, but I'm wondering will I see any improvement if I chose to bi-wire the speakers? Are these amps even capable of bi-wiring? it seems that the outputs on the amp don't distinguish between HF or LF output? does that matter? 

3. And if I do bi-wire should I use a different set of speaker cables that have good performance with HF and a set that has good performance with LF? or will I still see improvement if I use 4 of the same cables?

Thanks!

https://imgur.com/a/4jbmr5T
glaspmart
Are there any audiophile friends in your area? Might be best to have them take a look and offer options. 
It's not difficult, but better to have someone with experience to help you out as you set things up.
 
Thanks everyone.

Im probably going to go the Mono-block route with XLR cables, and leave it at that.  Might tinker in the future if I get bored.  

But now Ive got to figure out how to properly integrate a subwoofer..seems like people really like REL?
@glaspmart That’s the best route. I did the straight mono-blocks (different brand of amp) and never looked back. My amps have a switch though, no special cabling.

The RELs are a easy choice. They use the Neutrik Speakon connector, so you just run their cable to the speaker connection along with the speaker (in parallel). The filters and amp in the sub do the rest. It gives a very smooth sound. I love the way it sounds and despite what @millercarbon says it’s much better that an integrated for me. You can generally ignore what he says, he’s just a troll.