Dropping the gain level on the Herron to the low gain position should pretty much eliminate any noise even right at the tweeter. Then you can leave the amp on the default(shipped) position. Should also give you more "travel" on the volume control.
My 1st Tube Equipment Experience
I just purchased a used Herron Audio VTSP-3A(r02) tube preamp, as a replacement for a NAD M12. I paired the M12 with a NAD M22 v2. My first impressions are the M12 has more detail, the VTSP is much warmer, which is what I wanted. The VTSP sound is definitely different. And while it lacks the M12 detail, I do like it.
With the M12, my speakers were dead silent when music was not playing. With the VTSP, I hear a slight hiss when I put my ear very near a speaker. With the M12, I used XLR from the M12 to the M22; XLR from my Parasound JC3 jr; and RCA from my Liberty DAC. With the VTSP, everything now is RCA.
Is a little hiss common when using a tube preamp and SS power amp with RCA cables?
With the M12, my speakers were dead silent when music was not playing. With the VTSP, I hear a slight hiss when I put my ear very near a speaker. With the M12, I used XLR from the M12 to the M22; XLR from my Parasound JC3 jr; and RCA from my Liberty DAC. With the VTSP, everything now is RCA.
Is a little hiss common when using a tube preamp and SS power amp with RCA cables?
- ...
- 48 posts total
- 48 posts total