My Cary PH 302 phono amp MM hum?

Thanks for your reply. Sorry for my ignorance but what is an "external SUT"? Also not quite clear on a "star earth". I do notice a little more noise coming from the right speaker. And it seems less loud when I don't have the TT ground wire connected. I played with the fixed and floating ground and also found it made no difference. Thanks for the suggestions on the on the MM solder joints. I will check those.

A SUT is a Step Up Transformer, typically used for low output MC cartridges.

03-02-12: Sharpe
Thanks for your reply. Sorry for my ignorance but what is an "external SUT"? Also not quite clear on a "star earth". I do notice a little more noise coming from the right speaker. And it seems less loud when I don't have the TT ground wire connected. I played with the fixed and floating ground and also found it made no difference. Thanks for the suggestions on the on the MM solder joints. I will check those.

Definitely experiment with the turntable earth wire.
If you are using separate mains receptacles try connecting all components to the same socket.

Star earthed means all the earths wires are the same length and connected back to the same point. I have made all my (DIY) power cables conform to this and connect back to the same point on my dedicated line. The idea is that this will give the same (low) resistance/impedance in the mains earth leads and discourage stray currents from running over component interconnects etc. - forming ground loops. I have no such problems.

I still suspect a ground loop. I only mentioned the solder joints because I have experienced that issue and it resulted in hum.

Hello Tobes, I have the original PH-302 and I wanted to ask your advice on changing the tubes. I see that you're using Sylvania 1968 era. What do you think of Sylvania 1944 army military VT-229/6SL7 GT?

I imagine your Sylvania VT 229s would be a truly good tube for the phono amp as long as they were quiet. How do you like them this far.