New listening room electrical design


I'm moving to anew house in a few weeks, and trying to figure out the electrical design.
My current room was designed by Rives and I have numerous dedicated lines in it, so, I'm somewhat familiar with the topic.
The new system proposed outline:
New dedicated subpanel, exclusively for the audio components (main located in the garage, adjacent to the new room).
I have 2 speakers (Avantgarde) with powered subs
2 separate JL Fathom subs
2 mono block amps (lamm ML2)
and number of front end component, locate on stand, that going to be on the side wall
(Preamp, crossover, TT and CD player)
I'm thinking:
Two lines with 2 duplex receptacles each to power avant-garde and JL subs
Two lines with one duplex each for Lamm mono blocks
Here is my main question:
For the preamp, crossover, TT and digital I have the following options:
1.   One line with two duplexes for the analog stuff
       Another line for digital
       3 duplex recptacles on 2 separate lines
2. One line (or two) and one power distribution box with 3-4 duplex receptacle, connected to the wall receptacle
3. Two lines hardwired (no wall receptacle and no IEC and power cord in the Power distr. box) to power distribution box, separating analog from digital receptacles inside the box

What is a better approach for the front end components?
Multiple lines feeding one duplex each,
One line feeding multiple duplexes
One line feeding power distribution box?
maril555
Post removed 
Thank you,
let me narrow this down
lets forget about digital for a moment, since it’s gonna be on a separate line.
if I had 6 analog components and needed 6 outlets for them, what would be the best solution?
1. 3 separate lines with 3 duplex receptacles ?
2. 1 line with 3 duplexes?
3. 1 line and power distribution box with 3 duplexes?
4. Power distribution box hard wired to one line without IEC and extra power cable?
Enter your text ...
@cleeds "It looks like these Lamm amplifiers can draw 1000 watts each. At 120V, that more than 8 amps."





That is incorrect, the ML2 are the low powered SET, not the high powered hybrids.
Power Consumption
225 Watts @ rated output @ 16 (8,4) Ohms.

I have no idea if that changes the conclusion about how to best wire. More importantly, keep the Mick Jagger mugshot photo on display in the new room! Cheers,
Spencer

Thanks sbank, I knew that figure cleeds gave was not right.
Maril, for my money, I would go with #3.
As I said a dealer may be a good person to contact for the best info.
Johnny R (audioconnection) is an a Agon member/dealer. I would trust his opinion on anything regarding Hifi.