New To Tubes Advice Needed


Hi Guys:
Like my question says I'm very new to the world of tubes. I have recently purchased a Xindak MT3 tube Integrated and I'm very pleased with the warm sound it produces in comparison to all the SS amplifiers that I have used over the years. I based my decision to purchase the Xindak based on the sound I heard and not the fact that the unit is made in China. This being my first entry to the world of tube gear cost was somewhat of a concern just in case I did not like the sound in the long run. The unit runs on 4-EL34, 2-68NP (6SN7GT)and one 12AX7 stock tubes original to the unit. I have read that tube rolling could yield some good improvements, since I know nothing on the subject I was wondering if I could impose on some knowledgeable members to guide in so far as to what should be changed and what with. I'm aware that there is so many different tubes on the market and that buying one over the other is a matter of taste but in my case I'm totally in the dark so any guidance is valued.By the way I would like to keep the cost factor in to play so no suggestions for very expensive tubes. Also I have read that EL34 could be substituted with KT77 what is the difference.
Thanks in advance for all of your input.
RossQ
rossq
Why not start easy by just rolling the 12AX7? There are a number of affordable choices that you can buy and try. Try to buy from a reputable dealer. If you like what you hear, consider rolling the other tubes.

Have fun,

--Ken
Hi Rossq,

I would first give the unit some time to break-in and for you to become familiar with it's sound. Then you may want to try they 12ax7 and the 6sn7's first. You only need one 12ax7 so you could do that one first. What kind of sound do you want and how much are you looking at spending?
Hello Rossq,

I was in the tube way before the Solid State came along and my soft side is always the with the beautiful sound of the tube. I am glad to hear you have discovered the same. The upmost important thing in this hobby is the way YOU liked it. Not someone who's trying to tell you what's his preference. Each one of us heard the music differently. That's why there are so many brands and companies to choose from. I don't know anything about your amp. I put my amps together from the kit and after few nights slinging the soldering gun, I am really enjoying it (Bottlehead's Paramours) and after a few years, am still loving it.

Yes, tube brands make different sound. You could tell the difference from one to the other when you rolling the tube. Stick with what sound the best to YOU. My other advise is to pay attention to the front end (CD, Turntable, etc.). If garbage in, it will be garbage out and your first watt is the most important to you system. Do not spend your 401K chasing the rainbow. Just listen and if you liked and that's is.
Enjoy the music!
Replytoken-Detredwings and Wynnsanantonio.
Tanks so very much for your input. So just so that I understand I could start by just changing one of the tube the 12ax7 and see what happens, if I was to change the 6SN7GT I would have to change both of them. Now since there is 4 EL34 when changing I would have to change all 4 is that right? What happens if one of the 4 EL34 burns out or is faulty would I then need to replace all four once again and would I have to replace the burned one with the same make. The Integrated sounds just fine as it is but you know how it is just trying to refine the mid range and see if I could get the base to be a little faster and tighter.