Noisy AI Mod 3A?

Oh, I should have added shielded connectors with a WBT-like connector. The AI sockets or whatever you call them seem to be slightly smaller than standard, and sometimes I think a less than tight grip will cause a hum.

These things are extremely picky about tubes as well... Make sure you research tube changes... For your problem, you may want to try cones underneath the unit in both directions -- tubes selection combined with the chassis noise of this thing or other components may be amplified in a microphonic nature. I had a friend that went through this and found his 'fridge on the wall behind the audio gear was creating enough mechanical vibration to disturb his AI Mod 3. His fix was isolation (zoethecus stand & cones under the preamp) and different tubes that were less microphonic.

J_k brings up a point I forgot to mention. Anything else plugged that's plugged into you electrical system could cause a problem. I forgot about that and when my speakers started humming and buzzing last night, couldn't figure it out until I unplugged an old tuner I had just plugged in. Interconnects didnt matter, it was the power cord or the lack of grounding or something. Tubes can make a difference, but I have noticed that different units will hum or not with the same type of original equipment Sovteks.