Pass XA30.5 enough power for Wilson Sophia 2?


I was wondering about this combo. I have a very large room. Personally I dont think it's enough power but what do you guys think?
nickt
Tvad is correct.

The point to using a ratio that approaches 100:1, or that is much larger than 10:1, would apply to the situation where the only output impedance specification that is available is a nominal rating, that presumably applies to mid-frequencies. In which case using a high ratio would allow for the rise in output impedance that commonly occurs at very low frequencies, especially in tube preamps, due to the output coupling capacitor.

In this case, worst case output impedance data for the Ref3 across the entire frequency range is available in JA's Stereophile measurements. The worst case, which as can be expected occurs at 20Hz, is 1437 ohms in balanced mode. That is well under one-tenth of the input impedance of the Pass .5 amps, and therefore should not be a problem.

Also, in situations where this issue may be a problem I would expect the symptom to be attenuation of the deepest bass, not muddy bass.

Regards,
-- Al
Can you match the Pass amp with a tube amp? Yes. And I highly recommend it. It will give you the best of both worlds.

Do I ever wish for a tube amp with this combination? Absolutely not.
Thanks for correcting me.

I haven't had good experience driving the Pass with tube preamps. I've tried the Cary SLP-05 and the Audio Valve Eclipse and the low bass is rolled off. It's one of the reasons I got the Bat.

I'm currently auditioning a Ref 5 (with my Bat). I'll have to try it with the Pass and see how it fairs.
Post removed