Passive preamp issues or?


I have a Nuforce STA 200 that I’ve been using with an Axiom Walker mod preamp for a while now.  Other equipment is a Bluesound Node 2 streamer and a Jolida dsd dac.  Nordost digital coax and Dueland Schroeder IC’s from dac to pre and pre to amp.   Last night, I disconnected the preamp and ran the IC’s directly from the dac to amp, using the volume control on the dac.  The change in detail and depth was not subtle.  Soundstage extended beyond the speakers- everything just sounded better.  However, with the high gain of the Nuforce there’s  a hum in the speakers- it’s not not audible when I’m not playing anything. I’m willing to live with it, but I’m curious why the sound improved significantly by pulling the pre- should I look at better IC’s from pre to amp or is the Axiom subtracting from the sound quality?
renisnceman
From Michael Allen at Jolida/Black Ice- “the spec is 47 K ohm.”  The volume control is analog. 

I’d say without ever doing the experiment to see on the test bench or hear also, this 47kohm output impedance "could" be the problem. As it will also be "capacitor coupled" as well being tube which "could" make it even more of a problem if the caps not large enough, or an electrolytic, who knows, as it’s not following the output input >1:10 "rules" as we know them.

Cheers George
I put the pre-amp back in the loop.  Dead quiet- decided I couldn’t live with the hum. FWIW- and I don’t clearly understand the logic behind this, if I keep the amp connected to the speakers and disconnect the dac from the amp, the hum is worse. Disconnected every that might contribute to the hum- no change.    I may just look at better IC’s from pre to amp to see if I can wring some improvement.  It’s really a pretty good system as it is- I may just need to tweak with the pre in the loop.

As I asked you to put in your Blue Note 2 in, did you? (which also has volume) Direct into the poweramp, and then you can see if the problems disappears.
If it does then the Jolida tube output is the problem, and even if it doesn’t make noise will still be an impedance mismatch at 47kohm with the input impedance of the Axiom pre also.

Cheers George