PLEASE match Advice Pass Labs X350.5 (20k) to Hovland HP-100 (2500ohms) Miss-match ???


GUYS / GALS NEED YOUR HELP PLEASE!

A friend said this preamp is outstanding and will sound great with Pass Labs amps and to not get caught up in the specs but the measurements say different.

Pass Labs X350.5 amplifier with input Impedance 30k ohms Balanced or 20k ohms Single ended* 
(*source Pass Labs Manual)  

Hovland HP-100 source impedance 2500ohms* 
(*source Stereophile) 

Guys / Gals, can I used my Pass Labs X350.5 amp with Hovland HP-100 preamp? Has anyone used Pass amps with Hovland pre's. I will be using Magico S5 Speakers and Bricasti M1SE DAC but want it to sound the best it can. Should I just stick with the Aesthetix Calypso pre I was leaning toward before my gut said to go for the Hovland HP-100

Hovland HP-100 Preamplifier: * Output impedance: approximately 2500 ohms or according to Atkinson, Hovland HP-100 (2500ohms) its source impedance was high at 2.4k ohms, rising to 4.3k ohms at 20Hz. The partnering power amplifier would best have an input impedance of at least 47k ohms if the bass is not to sound lean*. The Pass Labs doesn't meet the x10 requirement it is supposed to but it is sort of close when looking at it. What do you guys think? I am not sure what to do but you guys will know what to do?

Stereophile: Its input impedance was a usefully high 100k ohms in the midrange and bass, with just a small reduction to a still-high 86k ohms at 20kHz. Despite the claim that the HP-100 uses a cathode follower output stage, its source impedance was high at 2.4k ohms, rising to 4.3k ohms at 20Hz. The partnering power amplifier would best have an input impedance of at least 47k ohms if the bass is not to sound lean.

Read more at https://www.stereophile.com/content/hovland-hp-100-preamplifier-measurements#YZXZfGLbbL2COkLR.99 https://www.stereophile.com/content/hovland-hp-100-preamplifier-measurements#YZXZfGLbbL2COkLR.99
128x128Ag insider logo xs@2xfsmithjack

fsmithjack, thanks for the update. Sounds like you (finally) found your matching components. Start a new thread in the Analog section and get the input you need from the gurus over there. There are some serious hardcore vinyl folks who hardly ever cross over to any other section, especially Digital even if their life depended on it....😁

Enjoy the journey.

I had this same burning question. Nelson Pass answered it for me himself. He said the Conrad Johnson single ended triode was an excellent fit for his amps and highly recommended the pairing. Look on the DIY sites where he frequents or email him yourself.
I was skeptical as well and borrowed a Pass XP10. Lovely preamp with many things I like about it. The really real was that my CJ Pre’s and I have a few; all attenuated better; sounded best with my CJ Premier 16LS2 and my CJ ET-5. Nelson was correct.
I can agree with jahatl! Get a CJ ET-7se and be done with it. One of the top 5 preamps in the world today. GAT 2 being the other one. Cj has the prat thing going for it which makes other preamps sound less analog!
If your speaker is neutral u dont need all tubes. Cj pre with pass amp great combo. If you get tube pre and tube amp. You will lose prat & fine detail. Nuances! I had set before sounds nice but loss of fine detail and bass dynamics. But to be fair my speakers weren't really efficient.