Power Cables on Subwoofers do Matter


I read an opinion somewhere on this site that swapping the power cable on a subwoofer has a minimal effect and may not be worth it. I have a very different opinion. Power cables can completely transform a subwoofer’s performance.

I have an SVS SB-2000 powered sub and my preferred power cable, a Zavfino Fina, has made it sound like a different animal altogether. It has much more punch, freq response linearity, and liveliness. The manufacturer included power cable makes it sound slow, bloated, and almost out of tune just because it’s sloppy, in comparison. The only drawback to the Fina is that slam below 30-40 hz is a little recessed but it’s not major and is still clearly my choice. I also compared five other aftermarket power cables from other components in my system and they ALL had a different effect on the sub. For testing, I used various crossover points and most of the testing was with the loudspeakers off in order to isolate the sub for critical listening.

Cheers!

128x128gladmo

Built my own 10awg cable for my sub as well. Noticeable positive improvement. 

@williewonka

Hello Steve,  thanks for the quick overview about cables but from Furutech spec, the FP-Apha 3 doesn't have copper shield like the others power cables. 

Does it mean we can not connect the shield to the ground wire on the male connector for DIY power cable?

Daniel

As a side note to the discussion for anyone doing their own subwoofer cable swapping, I've found the synthesized bass line in the song "In Too Deep" by Jacob Collier to be particularly useful in evaluating sub-bass qualities.

Power cable makes a difference?

The current is sourced from a transformer placed somewhere far away outside the building. Then it passes several long cables to the building main panel where is distributed through other cables to each apartment or whatever place. Then it goes in the home distribution panel and then to each plug. 

If someone is saying that the last 2 meters of cable can change the sound of a subwoofer while the current is passing through hundreds or thousands of meters of cables and hundreds of connectors + a few panels ... maybe they can explain us how !

I can understand that the RCA / XLR / or other cables placed between a sound source and final speaker can make a difference (if really bad cables are replaced with decent / cables) but the power cable can do absolutely nothing unless it is damaged or too thin. 

 

Post removed