power conditioning question gentlemen

      I,m considering a power conditioner /surge unit ,Two sunfire subs,nu vista intergrated(draws some juice) ,transport,dac,tt, phono section (dc-ac i may just plug in wall)  .Dedicated 20amp run directly to room x 2 hospital grade rec. I have been looking into richard grays,furman ref,shunyata etc.I have a unique set up here in nor cal.I am completley off grid!,I run a serious solar and res set up with a genny back up.The power is pretty consistant although during changes in genny start up or at time it does fluctuate a little .I never hear it or have never measured a spiked it drops slightly during those milliseconds.I would like to snag a used one in the 1k range .

Can you measure the voltage and THD of incoming current that you are getting? And the turntable speed.
Power conditioning can be a complicated thing, you might have to experiment a lot. My case was simple - I had fluctuating voltage and dirty current in the apartment. Until very recently I was using inexpensive Furman voltage stabilizer/conditioner. It didn't stabilize well, cleaned up the current a little but not well. Now I have PS Audio Power Plant Premier regenerator and the difference is huge. But your situation is different, and those two subs require an additional thought.
I would probably first try something with the turntable and phono only and then go from there. You could start with PS Audio Dectet conditioner from Music Direct for $400 that can be easily returned.

If the issue is the effect of the generator have you considered a battery solution to store power from the solar array? The Tesla product is an obvious option. Battery based power supplies are a big trend in audio with products such as the Stromtank. Looks like you could get the same type of setup at much less cost given your existing array
May I humbly suggest that using Balanced Power instead of pure "conditioning" might yield some amazing results. 

Please feel free to e-mail at corepowertech@outlook.com

Or call - 720.317.9141

Happy to help... happy to dig in and even lend you a unit to try.


I have seen the core power not in person though .. I have a 16kwh battery backup it was 10k not lithium it wasn't in vogue yet( 3yrs  old flawless matenence)  .. Last i checked when electrician was there i remember 117 hz i will double check . Thd honesty dont know how to check that . When the genny fires on it is only charging the batteries 12kw . It also has other leads that send power only when on , hence the size .. But when it goes off i can see a slight flicker in the florescent bulbs . I rarely run my 2-2 when its either low or not being charged . Sun or gen i have a meter in kitchen % amps volts . Ht room hairdryrs microwave electric lg fridge plasmas on  no sweat . I know my amp can deliver 40amps of power sometimes i feel like it may be starving when im rocking . Never hear anything just my mind wondering .
              Inna i would have zero problems plugging the subs into the wall but the amp which has an external power supply tt and phono sec i would like to address ..
Thoughts please  
My PS Audio unit shows me that in most cases incoming current has over 2 % THD and outcoming 0.4 %, that's a big difference that I can hear. 117volts should be alright for most equipment but some will sound better with 120V-121V. You could get the same unit, it shows up on Audiogon from time to time, the going price is $750-$800, and plug in your turntable, phono, cd transport and dac. Not certain about your amp and subs, that could be too much for the regenerator especially for subs, I guess. Just an idea.