Primare A32 front panel-rapidly flashing standby indicator light

Anyone own or owned a Primare A32 power amp and had problems with the front panel standby indicator flashing rapidly?  Over the last few months I've had to manipulate the rear left speaker cable inputs to hear sound out of the left speaker each time I turned it on.  But the unit always powered up and eventually played beautifully.  Now I get nothing.  I've disconnected and then reconnected the power cord, the XLR cables from the preamp, and both speaker cables.  The fuse is in good shape.  But the standby indicator still flashes when I try to power it up. A designer flaw I've found is that the front panel is attached by 6 tiny screws (2 on top, 1 on lower L & R side, & 2 underneath).  For such a massive unit one would think the designers could've used sturdier screws.  The top right screw broke a while back and may have left a fragment in the screw hole (hard to tell it's so small).  The front panel now has a little wiggle room which may be causing some wiring hit and miss inside though I can't see how.  I've never pushed or pulled on the front plate after the unit was set up and it's played many months without problems.  I researched online and found Audio Elite Technician LLC in Lakebay WA.  The website says they offer factory authorized service for Primare gear (along with McIntosh gear).  Anybody ever dealt with these guys?  The A32 weighs 88 pounds and I'm not fond of trying to ship it out of state.  Should I try a local repair shop first?  I really love my system's sound and want the A32 back in the game so I can again lose myself in musical bliss.

Looking forward to your thoughts/impressions- mewsickbuff.

Happy Listening!

If you had a bad speaker wire, was that not the problem?  It sounds like out of coincidence both the speaker wire and amp were bad unless constantly needing to adjust the speaker wire broke the cables?
You're probably spot on about manipulating the speaker wire resulting in its breaking.  Sometimes I manipulated it at the speaker end and other times at the amp end.  For a while I was afraid my MA Gold 300 left speaker was a lemon.  But Audience sent my cables back (looks like a new pair).  I've reconnected the cables, speakers and amp (Onkyo until the Primare gets repaired) and both speakers play without flaw and sound pretty fantastic.
Great to hear.  Enjoy. Audience having a lifetime warranty, not unlike the long Bryston and Odyssey warranties is so nice.  You don't think much about it until something happens.  And these companies seem to put "honor" in honoring their warranties if the word of mouth is accurate.
OK just to let you know I have the same unit with the same problem. I am in touch with the folks in WA and they mentioned that there is an internal fuse which may have blown. If you look in the service manual you'll see where it tells you how to get the error code. If it is a blown fuse then it should be a relatively simple repair. FYI when I saw the rates to ship and insure the unit from the east coast to WA my head exploded. Good luck and keep us informed of  your progress.