Primare A32 front panel-rapidly flashing standby indicator light

Anyone own or owned a Primare A32 power amp and had problems with the front panel standby indicator flashing rapidly?  Over the last few months I've had to manipulate the rear left speaker cable inputs to hear sound out of the left speaker each time I turned it on.  But the unit always powered up and eventually played beautifully.  Now I get nothing.  I've disconnected and then reconnected the power cord, the XLR cables from the preamp, and both speaker cables.  The fuse is in good shape.  But the standby indicator still flashes when I try to power it up. A designer flaw I've found is that the front panel is attached by 6 tiny screws (2 on top, 1 on lower L & R side, & 2 underneath).  For such a massive unit one would think the designers could've used sturdier screws.  The top right screw broke a while back and may have left a fragment in the screw hole (hard to tell it's so small).  The front panel now has a little wiggle room which may be causing some wiring hit and miss inside though I can't see how.  I've never pushed or pulled on the front plate after the unit was set up and it's played many months without problems.  I researched online and found Audio Elite Technician LLC in Lakebay WA.  The website says they offer factory authorized service for Primare gear (along with McIntosh gear).  Anybody ever dealt with these guys?  The A32 weighs 88 pounds and I'm not fond of trying to ship it out of state.  Should I try a local repair shop first?  I really love my system's sound and want the A32 back in the game so I can again lose myself in musical bliss.
Hi all,
I have a Primare A30.2 power amp.
A week ago I had the same issue, the front standby led kept flashing when powered on.
After reading this status I bought a bit T8 and did open up the cover.
Indeed one of the 3 fuses was blown.
Accordingly I bought the new fuse 6,3A 250V and replaced it.
The problem was just over.
And I am very happy now.
Thank you you all for sharing this issue.
Hi all, I am a new Primare A32 owner, and I have some challenges witht flashing light and even lost power, respectively punch in the bass. 

I drive some nice elac 507 which can handle the power, and my cables are naim nac a5, which should be fine. 

After two weeks, i kind of had the feeling that bass was slowly going away. Normally u had to reduce the bass in my streamer, but it was not needed any more, i could even increase the bass, but the punch was not impressive. Some day later flashing light. When i opened it, all 4 fuses wirh the 6,3A were burned.  

I replaced them, everything was fine.  Now 5 days later i am again missing punch. Now when i switch on the amp, the light flashes for 30-60 seconds, but then it goes on and works, just punch in the bass is missing. 

Its also confusing, that in standby the light is off. In the past it was always light green. 

Any idea in this round?

i am especially confused by the power reduction does the amp has any safe mode, where he can reduce the power which is send to the speaker once he recognises any problems?