PS Audio vs. Monster - cleaning up the power


Here's my question. Which way do I go now? I have my fused, dedicated 20 amp lines installed. Do I go with PS Audio Ultimate Outlets and Juice Bars or a Monster HTS 3500 or 5000? From what I read here and elsewhere, these are all great products at affordable (for the audiophile game anyway) prices. I was thinking of going with a 20 amp UO for my big amp and the Monster for the front end and video. Is there any benefit to using a UO in front of the Monster? Thanks, as usual, for your collective wisdom.
jphilips
I will suggest you buy a used PS Audio PP-600, plug it in one of the outlet of the dedicated 20-amp line, and plug all your front-end audio equipment to the pp-600. I will than plug the power amp to the other outlet of the dedicated 20-amp line. This will give you a regulated power and isolation for the sensitive front-end and a star grounding connection of all your equipment. Star grounding is the key to eliminate ground-loop problem.

The PP-600 will cost you a few hundreds more but the cost/benefit ratio is much higher than UO+Monster. You don't even need the latest PP-600. A used one without powerport should run about $1500 on Audiogon.
Sidssp. What is star grounding? I have two dedicated 20 amp lines with a common ground back to the panel. I already have a Juice Bar and would buy used Monster. Just can't swing the $s for the PP600 right now. For now I'll plug the amp (Musical Fidelity M3 integrated) directly into the wall using a Virtual Dynamics cryoed Audition PC.
Star grounding is a grounding technique that connects all the ground wires to a single point and than connects that point to the ground. The resulting topology looks like a star and hence the name star grounding.

Ground loop hum is caused by the relative voltage differences at the ground levels between different components. So if you plug you power amp into one outlet and plug your preamp to a different outlet, it is possible that the ground wires in the two outlets will have different resistances and therefore a voltage difference is developed between the two amps. When the outlets are new, the difference in resistance may be small and you may not notice much noise. But as time goes by, oxidation will develop on the contact points of the outlet, the bare wires, and the circuit breakers; and the noise will get worst.

If you plug both amps to the same outlet, the relative resistance is measured only between the two power cables of the two amps which is much less than going through the outlet, the wires in the wall, and the circuit breaker, and back.

I am not sure what you mean by "two 20 amp lines with a common ground back to the panel". But if I were you, I will plug the Juice Bar to one 20 amp line and than plug everything to the Juice Bar.

I hope this help.
Sidssp. What my electrician ran was a 10 ga underground cable that has 2 hot leads, 2 commons and a single ground. This goes into a junction box from which there are two 3 wire lines to the powerports. Thus, there is a common ground (I guess this qualifies as a star as you describe it) back to my fuse box. I will plug the amp into one of the lines, the front end into the other.