Question for Platter spinners regarding IC

@millercarbon 
Thanks for the reply. Already have the AQ Columbia in hand and wanted to know if anyone had tried it and to get their opinions. Would it do anything detrimental, other than SQ, to give it a try? Running a Ortophone 2m Black right now on the table. Down sized components and the Columbia was a very nice connection from my ex CDP to the Rougue. 

There is absolutely no possible way to harm anything by trying one pair of ICs versus another between the tonearm and your phono stage. It is sad, however, that a company like audioquest, which makes audiophile interconnects, does not list the capacitance of their cables, if that is really the case. However, there is no way to do any harm by trying. Listen for high frequency extension. Use what sounds the best to you. Pay no attention to anything else or anyone else.

In a phono connection you generally want shielded interconnects, but whether that is really important in your locale is only to be determined by you. Shielding per se increases capacitance. So often there is a trade-off, if your cartridge is particularly sensitive to capacitance. (In which case you may sense a slight roll off of high frequencies, as suggested.)

Turntable interconnect cables need to be ultra-low capacitance and should have both the signal and the “signal ground” leads shielded all the way to the phono stage. Most turntable interconnects rely on the “signal ground” as the shield, which is folly. Both conductors on each channel are signal-bearing. A true balanced cable with shielding to chassis ground is really what is needed. 

Thank you for your input. I called AQ but was on hold for quite a while before I gave up. I'll ask them via email next. Maybe I'll get a reply. I'm leaning on trying it and see how things go. It's an easy IC swap. I can always revert to what I have now. 

Just try it.
if you like it , it’s good.

Sleepwalker, in theory you’re correct about the importance of shielding, but in specific cases it adds nothing except unwanted capacitance. You generally cannot have “ultra” low capacitance AND shielding in the same cable. Keeping phono cables short as possible is the best bet.

but don’t scare the OP out of doing is own experiment.