Relationship between Ethernet Switch and SQ

This one will probably invite some withering mockery, but I will ask....

I only stream, and my streamer (Bryston BDP) is fed with an ethernet cable that runs back to my router.  Literally back to my router; there are enough output jacks on the router that I have a long run to the streamer and no ethernet switch in the chain (or the house system for that matter).   (There is an Eno filter right before the streamer).

I happen to OWN a nice LHY ethernet switch.  I am assuming that there is no reason to use it in this configuration, that is, assuming there are noisier switches, and less noisy switches, there is still no net benefit of adding any switch to this chain.  But maybe, just maybe, in the metaphysics of electrons that I do not understand, there is some reason why a nice switch prior to the streamer accomplishes something (in theory...I get that I can A/B test and try to fool myself whether I can hear a difference).  For the first person with a correct answer, I will mail a nice $600 switch to the address you specify! (JK)


Good points made by @lalitk. Just a small detail to add - when swapping Ethernet cables, power down your streamer (not in standby, but actually powered off). I found, with several streamers, swapping Ethernet cables while the unit is on results in sound degradation. Same applies to USB cables. This has been my experience. And in general, swapping any cables while the components are on, be it the interconnects or speaker cables, is just not worth the risk. 

@lalitk I appreciate your guidance and agree with your methodology....but you have unrealistic assumptions about my capacity for discipline and focus. 😂  I'm also getting closer to understanding why streamers can be $20K or why people could spend $4k on a switch or $2k on a filter.  Dorothy, we're a long way from "bits is bits"!

I want to double-click on what @tonywinga said, which countered my intuition, which is that adding another audiophile switch improved SQ.  How can that be?  I was assuming that any additional component that has a power cord can only be a net negative (even if miniscule, in the case of $4k switches).  Unless good switches also ....filter ...or "regenerate" the signal, or have some property similar to impedence matching.  I'm not arguing that something heard was not real, just trying to understand the theoretical basis. 


Apologies, I did not intend to doubt your capabilities, methodology or focus. It was more like a cautionary advice drawn from my own mistakes and experiences 😊

@lalitk I think my joke missed - what I meant is that you implicitly expressed confidence in my capabilities and focus...which may not be grounded in reality. 😂