The smaller network on the output end of the Transparent Reference XL speaker cable. It consists of a 1000 pF capacitor and a 31.7 ohm resistor.
All you do here is solder the cap and resistor together. Then, use your soldering iron to melt away the insulation on the positive and negative legs of the cable 12 inches from the output end.
It is a HP filter 25K or higher. This is for a 3 meter run. You'll be just fine, though. The other end has a hand wound inductor and couple of other parts. There are two parts of the network.
Regards
All you do here is solder the cap and resistor together. Then, use your soldering iron to melt away the insulation on the positive and negative legs of the cable 12 inches from the output end.
It is a HP filter 25K or higher. This is for a 3 meter run. You'll be just fine, though. The other end has a hand wound inductor and couple of other parts. There are two parts of the network.
Regards