Room EQ


For those who are using room eq, what are you using and describe your results.
musicnoise
I use Fuzzmeasure with a Behringer ECM8000 and E-Mu 0404 USB Mike amp - it is a very similar setup to Room Eq Wizard. Measurement plots are displayed on my virtual system. I use it for bass calibration to the sub only - speakers are run full range without any EQ. Fuzzmeasure uses a chirp or sweep which I prefer for running tests (very quick).

I suspect something like this is essential once you have done all the acoustic treatments that you can accept aesthetically. It certainly helped me correct for what was too much bass and too much room modal response at certain frequencies.
I've tried the berringer a few times and find it's not very transparent. I would'nt use it for anything but the bass frequencies. I have not tried any of the more expensive ones. They would have to be way more transparent for me to consider using one.
Sarcher30- Try one of the TacT Audio systems(with a MauiMods power supply). If you are not opposed to actively bi-amping: the RCS 2.2's are transparent enough not to lose a bit of ambience, timbre, soundstaging(width/depth) or image information, while providing a beautifully clean mid/high response. I own a DEQ 2496 to test/verify my steady-state freq. response. You can't beat the price for a 6th octave RTA. It's never IN the system though, for the same reasons you've stated.
Shadorne: Are you using the E-mu 0404 USB recording interface or the E-mu 0404 USB Audio/MIDI inerfact. I believe they both have microphone amps, but different output capabilities.