Should Amps be plugged into a power conditioner?


Greetings,

After reading about the amplifier hum, it was mentioned that some knowledgeable people say NOT to plug an amp into a power conditioner. Plug it directly into a wall outlet. Thankfully, I do not have a hum issue, but am curious as to what others say about where to plug your amp into. 

Thank you!

lovehifi22

Interesting thread. I have a Shunyata Denali power conditioner and have had an Luxman L-507ux MK2 integrated amp plugged into it since purchase. I’ve had the same performance described by jsalemo277 above. Having never tried plugging the amp into the wall directly I have no idea if the less restricted dynamics ghdprentice described of might be obtained by doing so.

So I’ll try that out tomorrow and see.  The pre-amp portion of the integrated might be negatively impacted by decoupling it from the Denali, so I’ll try and notice if there is any noticeable issue there as well and report back.

Mike

My Pass Labs mono blocks are plugged directly into to separate wall sockets, which is the recommendation from Pass Labs. Other components with less current draw are plugged into an Isotek conditioner. 

I have used  power conditioner for around 17 years I thought it made a difference in the sound quality of my Denon 4308 and the picture quality of my plasmas, (oleds presently) . Denon still gives me phone support and always asks if I'm using a power conditioner and to unplug it and plug it straight into the wall, I have a lot of power surges here with every thunderstorm once the power goes out the unit stays off until I turn it back on. gives piece of middle in the middle of the night when the power is going in and out..

From the info in the preceding posts, it would appear that plugging my amp directly into the mains socket would be preferable. Unfortunately, my mid-century home has ungrounded circuitry in most areas, including my listening space. When the amp is plugged directly, there is a small amount of current flowing through the cabinet that can be felt by touch. I found that by connecting the amp to my  Panamax conditioner resolves this issue. I hope to upgrade the circuitry, at some point, but in the meantime I'll have to use a conditioner for my amp.

I’ve also been very happy with my McIntosh MC500 plugged into my Shunyata Triton/Typhon Combo. I’ve  never had any issues.