Simple and Effective Upgrade for Wall Wart Power Supplies

I recently purchased a new DAC that is powered by a 12V wall wart power supply. In trying to extract the best sound from the new DAC, I turned my attention to the power supply and power cord. Upgrading the power cables on my other pieces of equipment yielded great results, so why not try it with my DAC?

I looked into upgraded power supplies and was quickly overwhelmed by the number of options and reviews and I wasn’t really in the mood to drop more money on my source at this time. I reasoned that the little cable that runs from the power supply to the DAC could be improved on but it’s all one piece and I didn’t want to rip anything apart. I had a spare C7 connector power cable lying around and tried to figure out how to include it in the chain. I went on Amazon and purchased an adapter to go from a “female C7” connector (proper name: C8) to IEC connector. I bought another adaptor that went from “female IEC” (proper name: C14) to a NEMA electrical outlet style plug that I could plug the wall wart into. I hooked everything up, turned on the system, and let it warm up. I now had a high end power cable upstream of the wall wart, instead of directly plugging the wall wart into the wall outlet.

The first track I put on was “Bloodflood” by Alt-J. If I had to sum up the improvement in sound I heard from my improved power supply chain, that word would be: ridiculous! There was so much more slam to the music. Dynamics improved along with better instrument separation and a 3D soundstage became more apparent. Since I had a spare power cable laying around, the total cost for this upgrade was $11.16. I highly recommend you give this a try if you haven’t done so already.

Happy Listening!
Bumping for visibility since I posted late last night. 

Has anyone tried this same setup? Is this a common thing to do?
Thanks for the tip. So you basically daisychained the C7 power cord with the existing wall wart using various adapters?
While it may seem off that inserting an extra length of wire improves things I suspect a plausible explanation may be that the extender improves the quality of the connection between wall wart and socket. Wall warts are often heavy and pull down on the wall socket, in turn they're likely to pick up vibration further affecting the consistency of connection. Using an extender can allow you to position the wart/transformer away from the wall socket in an ideal location and hence deliver the improvements noted.

Interestingly I had a similar experience using a short extender where I needed some more length on a wart powered device and found far from making it sound worse it sounded a tad better (and I used generic non grounded extension cords) -- I'll look into making up some better short connectors so I can explore this further