SMc Audio: The Interocitor One thoughts?

One last attempt at getting some thoughts on this product before the thread goes into the archives.

I can't offer any opinion on the product, but the name is witty. The Interocitor was a communication device in the classic '50s sci fi movie "This Island Earth." Aliens sent them to prominent Earth scientists as kits. If you could assemble the Interocitor, you were smart enough for the aliens to be interested in you.

Thanks Robdoorack for the info. That is pretty cool stuff.

I had one here a couple of months ago. My system currently requires the use of Jensen transformers to convert the single-ended signal from my Tom Evans preamp to a balanced signal that goes into my Clayton amps.

Steve says he has constructed the Interocitor One using very high quality parts and he was convinced it would improve on the Jensen transformers (which I have never even noticed to have an effect on the system).

As currently designed, the Interocitor will correct an impedance mismatch as would be experienced when trying to pair a tubed preamp with high output impedance (that may occur at lower frequencies due to the size of coupling caps used) with lower input impedance amps such as Pass, the McCormack DNA500 and others with input impedance in the 10-20K ohm range. The impedance correction is also helpful if long interconnect runs are needed and has a side effect (benefit) of reducing gain so it would be further helpful with high gain preamps (such as some CAT models) into sensitive amps.

I did not need the impedance correction in my system since the output impedance of the TEAD preamp is only 12 ohms and Clayton amps have an input impedance of 100K ohms. Therefore, it did not improve the sound for me but it was every bit as effective at converting a single-ended signal to balanced as the Jensen transformers. Steve could construct the Interocitor One with different input/output impedance values and he may construct a 1:1 impedance version of the Interocitor One for me to try since I simply need the signal conversion and ground lift capabilities.

In summary, the Interocitor One is not inexpensive but it is a well constructed piece made with very high quality parts. It should work well in high end systems (or any level of system) to solve a wide variety of impedance mismatches, single-ended to balanced conversions (in either direction), gain matching, ground loop issues, or to facilitate longer cable runs. While not needed by everybody, it should play well with the highest level of equipment and may open up the use of a wider range of equipment parings through its ability to match connector types, impedance and gain. I hope this helps. If you are interested or desire more information I suggest calling Steve.