SME 3009 S2 Improved Tonearm problem...possibly


I’m struggling with my vintage turntable setup. I’ll give a run down of my setup and what all has been done and the problem I’m having.

Thorens TD125 MKII Turntable...New Walnut Plinth. Caps have been replaced. Strobe works as it is suppose to. It has a lexan tonearm board. It has been leveled and regulated. Still has original power cable. Original Thorens platter matt

SME 3009 S2 Improved tonearm with removeable headshell. Bronze knife-edge bearing properly installed. Aftermarket brass low hung weight. Original wiring in good condition. Upgraded to RCA connections. I have installed the SME fluid damper and using the recommended 200,000ct oil.

Soundsmith Zephyr MIMC * Cartridge with less than 50 hours just purchased new. This was spec’ed to me by Soundsmith.

Phone preamp is a Gold Note PH-10 with seperate power supply and is set to correct specs recommended by Soundsmith and tested by myself.

I just put a 3" walnut butcher block under my turntable. Put hockey pucks under the butcher block and installed spikes under my turntable.

 

I am experiencing midrange distortion. I’ve noticed today that piano is heavily distorted. The music isn’t as lively sounding with the Soundsmith cartridge as with the Shure Type III V15 I had on before. However, it should be a much improved sound.

I noticed today, as I’ve been tweaking the table constantly, while I was adjusting the tonearm height that with the table on and attaching the allen wrench to adjust height that I was getting a buzzing sound through the speaker. This would happen when the allen key touched the base of the tonearm or any point on the tonearm. Could this be the source of my distortion? If so, what is the possible fix?

 

This is driving me up the wall!!!

 

jebcamaro

@jebcamaro 

You can do a test - balance the arm to 0 so that it floats.

Make sure it doesn't tend to drift to one side. 

Try blowing it horizontally to see if it moves freely in both directions.

You cant tell by just lifting the arm - we are talking milligrams when it comes to bearings.