sophia 845 markIII and cary 211M AE


specification of this tube:-

Sophia Electric 845 MK3 Vacuum Tube Specification

Nominal operating conditions and parameters:
Filament voltage 10.0V
Nominal filament current 3.2A
Plate voltage 1250V
Grid voltage -200V
Plate current 80mA
Plate resistance 1.7 Kohms
Amplification factor 5.0
Load resistance 3.4 Kohms
Signal voltage(pk) 69.0V
Output Power 25W

Limiting Operation conditions for safe operation-nor simultaneous ratings:

Maximum plate voltage 1250 volts
Maximum plate dissipation 75 watts
Maximum plate current 120 ma
Maximum input power of signal 150 Watts
===========================
CAN I USE THIS TUBE WITH CARY 211m AE
AND WHAT ABOUT IT SOUND.
woodpark
Based on the above noted specification, yes these tubes will work in your Cary AE211 without issue. I have a lot of 845 tubes, but unfortunately, not the Sophia 845 Mk3 Carbon plate, therefore, I cannot comment on their sound.
Woodpark, what tubes do you have in your 211AE now?

It would be nice if you could report back on the Sophia's once you have them installed. I have the same amp, and would like to know :)
Amfibius,tubes used now are original tubes from CARY.
You can read about Sophia tubes in this web.
http://www.sophiaelectric.com/
I shall got new tubes about next month.
I got sophia tube last month but they could not be used with Cary211M,fuses of 300B blow out when open the power on.This is the answer from Sophia "The problem was the Cary 845 amplifier operates at a relatively high voltage and our 845 burning process voltage did not set high enough (about 1000V)"