SOTA STAR Sapphire Turntable Care and Feeding

I'm seriously interested in a used SOTA STAR Sapphire Series III Turntable with Vacuum, Electronic Flywheel and SME Series IV Tonearm, that is close to me and a very reasonable price.  It would be a big step up from my current Pro-Ject X2B, but I want to make sure it is not too technical for my dinosaur brain before I pull the trigger.  How difficult it is to get set up?  Once it is set up, do you need to constantly fuss over it or just the occasional check?  I have an upgraded Joliida JD-9 phono pre-amp.  Would this pre-amp be sufficient for the SOTA  or would I need to upgrade that to do justice to the SOTA?  Any other quirks of this turntable that I should be aware of?  Thanks in advance for your advice.


John Cotner

New Ulm, MN


Too bad.

That was a great price for what it is.

Sometimes you just have to hit the buy now button, THEN

think of an alibi when the S.O. finds out.


There's always a sunset on these things.  Not to mention a good dose of Christmas spirit while putting up the tree.


There is a neoprene tube that connects the vacuum pump to the turntable. That can be as long as you want. I am not sure what they did with the older Stars. The new units have the power supply in the pump and there is an umbilical cord that runs to the control unit. I suspect you have at least 10 feet. I put the pump right below the turntable on the floor behind a stack of records and you can not here it at all.