2. amps-preamps
  3. 1368812259

Spade connection size for McIntosh MC2155 Amp

I recently was given a McIntosh MC2155 as a family hand me down. I would like to incorporate this into a 2nd system. I'll be pairing it with a set of XR16. I would like to order some new cables but am not sure what size spades are needed for the amp side connections. Any recommendations on decent cable brands that accommodate the vintage sized spade connections?
btardugn
lapierre
547 posts
 
Analysis Plus will terminate your cable selection with barrier spade.

The spade is 0.32" wide, 0.04" thick and 0.68" long.

Opening will fit up to 0.19" screw of binding post.
roxy54's avatar
roxy54
8,002 posts
 
Zd542,
You are correct, and I should have made that more clear. If you choose, and assuming that there is enough space on the back panel, you can still have taps for all three impedances. For my amp, it would be tight, but I could have had 2.
cajunpepe
255 posts
 
I have a little wooden block made by Cardas with six inch leaders with small spades on one side and 4 multiple way binding posts on the block for exactly this use. I believe it ran about $100 or so a few years ago. I use it with an old MC2105 in the garage system.

Pepe
joekapahulu
250 posts
 
I got adapters in eBay for my mc250 so I can use bananas. They work fine for $6
roxy54's avatar
roxy54
8,002 posts
 
Joekapahulu,
I used those ebay adapters for years, and they made life much easier. They are not as secure as new binding posts though, and they don't sound as good.
More to discover