Speaker thoughts - ProAc D40R or Wilson Benesch

Milpai, the amps my dealer often uses with 48R's are the VTL tube stereo power amps. But they are pricey and on this occasion he used a

Prima Luna Dialogue HP power amp fitted with KT88 tubes. Surprisingly perhaps, the bottom end was fine, with pretty good control. So a good value combo. To my ear, the bass end on these speakers goes surprisingly deep given their exterior dimensions. Certainly, it is significantly more extended and morre tuneful than the Sonus Faber Cremona M's I used to own.

Thank You for the feedback. It is helpful to know that, since I do not have a dealer in my area.

I cannot offer a direct comparison experience of the Proac D40R and the WB line.   I still have the D40R and I continue to be amazed at how they perform in a huge room.   I would say the bass is ruler flat to 31 hz and useful bass in the 25 hz range.  On a test CD I can hear the 25 and 20 hz tone, but it isn't in the REL category.  The D40R bass literally loads my entire house....all floors and rooms.   It is quite impressive.   I have the VAC 160i integrated 85 watts KT88 and I run shotgun Cardas Golden Cross speaker wire....adding the second pair instead of using a high quality jumper was quite an improvement.  Front end is relatively simple: Rega RP8 w/ Ortofon Cadenza Black and a Cary CD300 tube CD player (circa 1995).   I still can't find a CD player that beats it and believe me, I've tried.  All Golden Cross cables and Shunyata power cables.  I've heard a few smaller speakers that do the midrange a bit cleaner, but not as full sounding.  Need to move up to YG Hailey or similar AND be able to drive with a high quality tube amp to beat these speakers on all attributes.  Good luck.

Toneaudio has reviewed the D48R very recently:

http://www.tonepublications.com/MAGPDF/TA_076.pdf

........but the problem was and I do not know if it has been ''fixed'' ; there was no US Importer for Proac. So who is importing them - and are there any dealers left in the US for Proac   ?