Has anyone tried using double runs of the Anti Cable speaker wire between their amp and speakers? In other words, two runs of wire for each terminal instead of just one. If so, did it make a difference and in what way? Thanks for any opinions.
Hey Rsrex, I had a licensed electrician install a dedicted AC panel along with a dedicated ground for my system, separate from the general house ground. I know I am OK up to the first ground rod. I will have to check on the Speltz cable to the second rod.
I tried it and could not get a good tight fit with the double spades on the amp end. The stiffness of the wire didn't help either -- one side would pop out while I was trying to tighten down the other side. Very frustrating. The sound from my Tylers was worse with the bi-wire, perhaps because the spades on the amp end weren't laying flat on top of each other. I went back to a single run with jumpers and the sound was more focused and dynamic.
You must have a verified phone number and physical address in order to post in the Audiogon Forums. Please return to Audiogon.com and complete this step. If you have any questions please contact Support.
