Sumiko tonearm rewire

About to dwell into rewiring my Sumiko tonearm. Just a few points before I start, if somebody went through this ordeal before.
The wire thickness - 34 AWG will be best? I am looking for 'warm' sound so I guess I should look at copper.
The wire insulation - what is better - silk or enamel?
Any particular solder brand I should be using?

I am not sure if it possible to take off the wand completely in other words to disassemble it, I can see that it is possible to get the wire through without taking it off, but on the other hand if I can take it off I would rather take it off, otherwise I may risk damaging the wire insulation.
Thank you
Wow! Never imagined the coating must be removed from litz wires. Please forgive my ignorance - why? OI thought the idea of litz strands was to minimize the 'skin' effect, but if coating taken off you got one thicker conductor? Or the flow will still follow each strand? My high school was a way back, I can't say how magnetic fields will behave when coating is taken off...
Now, with 46/10 litz you mentioned before - do we clean all 10 strands?.
I found a few places, I am sure I will find more but a few that just happened to make if first, would appreciate if you could share an opinion.
This one is 0.061 mm, enamel and silk on copper, not litz:
And here is litz:
- 81 (!) strands of 0.025 mm, silk covered. Do you think (as I am true Audiophile yet:) it will make sense to take 4 strands out of the 81 to make a single wire, and do it 3 times to get another 3? Have not seen any silk coated litz anywhere else yet...
Best Regards
Wait till you see how small a 46awg wire is. You can hardly see it.

Once you have cleaned off the ends, at both ends, you now have to start testing with an Ohm meter. This is to see which strands are which. Leave an entire evening for this.
Hi, wonder if I will need the flux, never solded wires these thin, or the using the Mundorf I wouldn't need that? They say the wire does contain the flux but I wonder if I's better to apply some of that? I am curious to know if there are any drawback in USING flux rather than not...
Thank you