2. amps-preamps
  3. 1289585470

Switcher needed

I have a small tube amp a friend made for me. I guess it's integrated in that it has one input, a power button and a volume knob. I'd like to get some kind of a switcher to select between different inputs. Need a min of 3 inputs, maybe four. Anyone have an ideas?

If I went with a pre-amp, how would that work? Would I just leave the volume of the tube amp at max volume at all times?
jksymz75
kr4's avatar
kr4
3,681 posts
 
There are lots of switches out there and any would be better than daisy-chaining a preamp unless you spent a lot of money on it.
jsd52756
433 posts
 
I had asked a similar question a few weeks back as I needed a switch as well. Ended up with a Goldpoint. Very nice unit from very nice people.
http://www.goldpt.com/sw4.html

Good luck,
John
clio09
3,355 posts
 
This should do the trick:

Decware Rotary Switchbox
buconero117
2,311 posts
 
Please take a look at the Chase Technologies RLC-1 Remote Line Controller. These can be found on e-bay, often for less then $50. The unit has four inputs, no phono, and the remote is a gem since you can do volume, balance, bass, tremble etc. It also has switched power inputs so you can turn on the attached units. I have two of these in some of the systems I run, one with mono block tube amps. They have been going for over ten years with no problems. Sound quality, amazing.
More to discover