- 62 posts total
- 62 posts total
I understand what you’re saying now. So basically you are relying on the power supply of each component to "clean-up" the AC before converting it to DC. Does that waveform need cleaning? What about fluctuations in voltage or EMF on the waveform? Can your power supply clean this up as it converts that "dirty" signal to DC? I think you can only know by looking at it on a scope. Why wouldn’t something like EMF carry over? What I do know is that with a balanced power unit in my system it is dead silent. If you want a good explanation I would search for the presentation by Garth Powell, formerly of Furman Power and the developer of the AudioQuest Niagara. Search for his presentation "High End Munchen 2015 - AudioQuest Niagara 7000" on YouTube. I would post the link but I believe A’gon won’t allow it. Watch that and read the white paper from Equi-Tech on balanced power and you tell me if it makes sense.
Fatiguing to listen to, glare, maybe muddy under some circumstances, lack of soundstage .I know this is not what you want to hear but when you add a good power conditioner, things will sound so much better! And you’ll know if it’s the right power conditioner, that also applies to power cords. You may want to audition a couple of different brands. Good luck they definitely make a difference.
1. Breakers for each of the 20amp lines placed in different areas away from each other. Can't hurt if there's space and was a recommendation by other forum members.
2. Siemens was another recommendation, basically just to use higher quality breakers because again, can't hurt.
3. Ran the individual lines when I had a new panel installed because it made it much easier to do at the same time.