Taming bright Thiels


I have been attempting for months to find a way to tame the brightness on my 2.2's. Ended up with a crudely simple short-term solution after much tube and cable rolling and equipment fussing (System is Theta separates, ARC LS2b preamp, Rowland 1 amp, Harmonic Tech cables).
I experimented with taping thin material suspended in front of the midrange driver to produce roughly a couple decibels acoustical attenuation in the 1Khertz to 3khertz region from each channel. (I experimented with 1- and 2- ply tissue, cotton cloth, etc.)
What a magical difference. My wife immediately asked for a listening evening, something she hadn't done in over a year.
So I wrote to Thiel (many times) and asked if a low-value resistor wired in series with the midrange driver would have the same effect with less likelihood of side effects.
While they responded to every query promptly, they absolutely would not give any information on any possible modification of the speaker to attenuate its overly bright character.

Anyone attempted such a modification? Results? Caveats?
hug
IMHO, the LS2 is horrible, bright and edgy. I would look for a Rowand preamp instead of "improving" the sound by altering the epeakers' freq response.
I would sell them and get something else, and I do take my own advice, I have owned 2.2s and 2.3s and after endless changes in electronics and cables I gave up, I did get them to sound better but never great. Best results occured when I went to a tube preamp (VTL) and changed to MIT cables. The sound never was very natural on the high end. Ended up going with Virgos and ProAc 2.5s which better fits my music tasts. Good luck, these speakers will drive you nuts trying to get them right.
Thiels are absolutely fussy with the components that drive them. If you are determine to keep these speakers, I suggest playing with different tubes in your preamp frist and then audition other front end players, amps.

If you have enough patience, it is possible to get these speakers right and they will reward you with great sounds.

I use to drive my Thiels 22 with Classe, Audible Illusion, and Cal Audio. I now drive my Thiel 3.6 with Pass Labs 1 monoblocks, ARC LS2B Mk ll, BAT D5, WireWorld Gold Eclipse, and Audiotruth Dragon spk cables. Good Luck !
Tim, I'm glad you're learning something - I was once young and thought I knew everything, now that I'm older I realize I don't know S#@T. But I do know bourbon and I hope you took my earlier advice and upgraded to Jim Beam Black from Evan Williams...:-)...
Could be your room. But it is hard to treat your room without change its look. I would say change to a not so bright speaker. That's a quick and direct solution. Lots of people already try different electronics and cables(bright & soft/ss & tube). Majority of people can't get the brightness tamed. Blame on preamplifiers or cables seem unnecessary. Usually electronics (include tube) and cable have a flat spectrum compared with any speaker. If your speaker can't perform flat spectrum in your room, changing electronics won't help much. Especially you already try some good electronics on both sides (soft and bright).

So I would suggested either move to better room or change your speaker. Edgy sound may appear "clear" in the beginning but starts to kill your ears min later. Sometimes, people are chasing that "clear" sound by wasting money and time on wrong equippment change.
Some just being lucky to have a soft room, and they have more chances to get good sounds out of your speakers.