2. analog
  3. 166122-18254

Technics SL1000 MK3 (SP10 MK3) performance/value VS modern turntables?

I have a Technics SL1000 MK3 in beautiful condition and in it's lifetime has seen very little use.
I am ready to send it off for complete electronics restoration/upgrade, upgrade the speed control processor module and have the Krebs mods done.  Will cost about $2500.00 to have all this done.

I was wondering how this would compare to what is out there for modern turntables after all the work is done? 
Or, would I be better off selling it, and adding what I was going to spend for the upgrades to a new turntable?
I believe these should sell in untouched condition for at least $5K?  So that would put me in the $7.5K range for a modern table?

For tonearms, I already have:
New, unmounted Moerch DP8
Fidelity Research FR64S, in beautiful condition that I sent off to Ikeda/Japan and they re-wired (better silver wiring, I still have original wires) and completely tore it down and rebuilt/re-lubed.... it's just like a new FR64S.

I think this table would be hard to beat at the $7500.00 price point, but would appreciate others opinion.

Rick

128x128Ag insider logo xs@2xrich121
richardkrebs
422 posts
 
rich121.
Thankyou for clarifying things, appreciated.
 And yes, our hobby should be the total opposite of stressful.

Cheers. 

 
tzh21y
1,654 posts
 
The SP 10 Mk.III may be the pinnacle of direct drive design.  I would keep it.  The new SL 1000R is a great table for sure.  It may be one of the best made today but I am not sure it is better than what you already have.  FWIW.
rich121's avatar
Ag insider logo xs@2x
rich121 OP
187 posts
 
@atmasphere
Very curious what platter mat recommendations you have for the MK3?
atmasphere's avatar
atmasphere
11,762 posts
 
@rich121 I like the Oracle platter pad a lot. One problem you may encounter though is that the Technics spindle really isn't long enough. So you may be only able to use a weight instead of a record clamp with that platter pad. The pad has to be stuck to the patter as well, so the screws securing the platter to the motor might be considered optional.
lewm
12,884 posts
 
tzh, way above the cost of a fully refurbished Mk3, there is a small universe of megabuck direct drive turntables, let’s say at prices of $30K and way up from there. Although I like my Mk3, I don’t assume that one or more of those turntables might not be even better. Surely, based on JP Jones data, the SP10R at a more pedestrian price point is as speed stable.
More to discover