The damper, the tension wire and cantilever position


This question is for Dover. I would prefer our ''heighest authority'' Carr but

am reluctant to bather his with possible silly question. Dover however,

whom I regard as ''second authority'' , is used to answer also silli questions.

Now my assumption is that damper to which coills are ,say, pressed

by tension wire  balance cantilever/stylu combo in  ''all directions'';

left and right and above and below . BUT they also MUST FOLLOW

the GROOVES.

My observation however is that also ''deviant'' cantilevers which

nobody would buy look STRAIGHT IN DE GROOVE. Ergo:: it is

the groove which determine cantilevet/stylus position .?

128x128nandric

boxcarman,

Logic apply for all languages while each languge has its own grammar Try to

state  whaever withouy ''X is P'' simple grammar construction. That is

the known ''subject is predicat'' costruction. Very poor for science. 

Try to get some lessons in logic. 

boxcarman, I made an mistake. Logic is to much to ask. Check instead  ''staw man''

strategy by ''discussion.'' . 

This post makes me tired.

And thankful that I only have two needles.

Of which I'm sure both are set up incorrectly.

 

Assertion that anti-skate causes crooked cantilevers IMPLY that NO ánti-skate 

dees  the same in opposite  direction. .