Tone arm holes do not line up - best way to attach TT?

Thanks for all your help. My pivot to spindle distance is correct according to the template that came with the Reed. I mentioned the 6" away from the TT to indicate how far away the arm would have to be to fit into the alignment grid. So I guess my arm is not compatible with my TT. I will contact Hanss. I made it 30 years in this hobby before I fell into the vinyl vortex. I guess I should count myself lucky. The sound is amazing but the complexities are daunting. Thank you all for helping this newbie. 

mcmanus

... My pivot to spindle distance is correct according to the template that came with the Reed. I mentioned the 6" away from the TT to indicate how far away the arm would have to be to fit into the alignment grid ...

Something is just not right. If the pivot-to-spindle distance is correct, then it should allow you to properly set the overhang, by definition.

Yes, something is not right. The spindle to pivot distance can be drawn as a complete circle around the platter and anywhere on that line is ok to mount the tonearm pivot. Of course most locations will present other issues. But if it is drawn at the proper radius any position will give you the correct geometry.
BillWojo

The sound is amazing but the complexities are daunting.

Its not that bad. It only seems like there are a lot of things to learn because right now you haven't learned many of them and so they seem to be coming at you from all sides. Its really not that many though and each one of them is really very simple once you break it down. 

Also while going through the learning curve it will serve you well to keep in mind what you already know: The sound is amazing! 

I have been buying, and playing, and modifying, and even building turntables since 1976. In all that time I have yet to hear the one that didn't sound amazing. There was even one time a gramophone in an antique store we put a 78 on and even that was amazing! 

I bring this up because too many audiophiles obsess so much on doing it perfect they miss out on a lot of opportunities to Just Do It! You could for example cut any old piece of wood up, put some holes in it, screw it to your table, and mount your arm to that. Just to hear how it sounds like that. Won't be much work (he said, having everything just sitting there in his shop all ready to go) and you will gain untold experience just doing it. And hearing it. 

Then send it back. Unless you fall in love. Which you might. In which case you go looking for better wood to make it all pretty and nice. Or send it back anyway figuring the shorter one will be all pretty and nice, and probably sound pretty much the same. Which you will never know- unless you try.

I read the thread, and I am still a bit puzzled as to the nature of your problem, because the Reed tonearms do not require drilling a large diameter hole to accommodate a vertical shaft.  They are all top-mounted, so far as I know. Which is to say they have a flat base that sits entirely on top of the tonearm mount board.  So, it seems to me that if your tonearm mounting board permits the greater P2S distance of a 12-inch tonearm vs your previous shorter tonearms, then you cannot have a problem, save the problem of drilling three small screw holes for the base of the Reed in a new location.  On the other hand, if the mounting board does not have space far enough away from the spindle to mount a 12-incher allowing for proper P2S, then you have a bigger problem than just the fact that the existing holes are in the wrong place; you would need somehow to extend the mounting board in that direction.  Which is it? Or what am I missing?