Tone arm holes do not line up - best way to attach TT?

Thanks for all the troubleshooting with so limited facts. The cartridge is Triangle Arts Apollo. The TT is Hanss. 

I only exceeded the weight of 2 grams as an experiment to see what it would take to get the stylus to sit in the grove. It went around for 1/2 a revolution at a slightly heavier weight. 

I am using a homemade arm board made from the current armboard and a walnut piece temporarily until I get one from the Hanss. That may affect the fidelity but not the functionality. 

The anti skate setting might be an issue. I adjusted it in and out and it did not make a material difference. I think the angle of the arm is far enough off that it is not within anti-skate adjustment range. 

If we go back to basics - When I put the center pivot of the arm at the specified distance, 296mm, the cart cannot be turned far enough on the tone arm shell head to be adjusted within the grid. So isn't that my core problem? Maybe I over complicated my "ask". Any solutions to that? 

You wrote, "When I put the center pivot of the arm at the specified distance, 296mm..."  Are you saying that you can set up the tonearm such that the distance from the pivot point to the axis of the spindle is exactly or very nearly exactly 296mm and that 296mm is the recommended distance per Reed? (This is in contrast to Miller Carbon's major assumption, which was that you are off by a "few inches".)  It's very important to clarify this issue.  Anyway, IF you have been able to achieve the specified 296mm for P2S (shorthand for "pivot to spindle"), that is good.  Having done that, what are you using for a template to guide you in setting up the offset angle of the cartridge?  Be sure you are using a protractor that is appropriate for the P2S distance of 296mm.  If you are using a garden variety template, it may be designed for shorter tonearms, which would result in the problem you note, that you cannot achieve the proper angle for the cartridge.  In reality, if you have the P2S set correctly, that should result in close to proper stylus overhang, and you should not need to do much twisting of the cartridge body at all, with respect to the Reed headshell, to get you into good alignment.

"In reality, if you have the P2S set correctly, that should result in close to proper stylus overhang, and you should not need to do much twisting of the cartridge body at all, with respect to the Reed headshell, to get you into good alignment."


Correct -  I have a Reed model-specific and arm-specific template and when lined up it is not possible to have the cart fall within the grid specified by Reed for that arm. 

The only way to get teh cart to line up is to not have the P2P as specified. If the pivot point is moved a few inches off the Reed specification then the cart lines up. But I cannot have both the P2P and the cart line up. 

What is P2P definition?