Tonearm relative to Plinth alignment

Thanks for your responses, everyone.

-Dusty

Dear Dusty: Like every one told you: If the overhang don't change then you don't have any trouble about, my only complaint is about the skating function because some tonearms has this function in a way that the antiskate grow-up all the way LP surface ( increment/higher at the inside grooves ) and the tonearm has to be a initial position ( outside groove ) where the AS is 0 ( cero ), if this is the case with your tonearm then you have to change the position for in the very outside record groove the AS measure cero.



Regards and enjoy the music.

Raul.

Hello Dusty, if you loosen the 3 bolts underneath there is a little bit of play to rotate it a bit for a slight amount of correction. The arm you have has a groove cut in the pillar so you cannot rotate the arm to swivel it to align.