Tubes trouble?


Need help and advice.

Have an ARC PH5 Riaa where the tubes were changed two years ago. Sometimes when I play there is a humming sound that changes character when I put my hand on the cabinet and all of a sudden I am completely free of interference again. Where do I start? Guess it's a tubes that's bad. How do I find which one? Can I change just one tubes or do I have to change all of them? Is there any placement of the four that is less critical if a pipe is in worse condition? Thanks fore comments and tips. // Niklas

titus1

I doubt that this is a tube problem. My first guess would be that it is somewhere in the grounding or wires (IC's). Check to make sure all of your IC's are not near any transformers, etc and all connections are solid, especially grounds from your TT and phono stage.

I agree with @newbee it doesn’t sound like a tube problem, good advice on likely fixes.

 

But for all my ARC equipment I have an extra set of tubes. If a funny noise comes up in a single channel, I change the tubes in that channel (or both if I don’t know which is which. If in both channels then the 6550. If this doesn’t work I change all the tubes just to be absolutely sure it is not a tube problem. If at any time the problem goes away, I swap in the old until I find the little bugger.

If all tubes are fine it is something else. For me it never has been.

To me this sounds like a mechanical hum. First thing to check would be the screws that hold the circuit boards and transformer are snugged. Then I would call AR tech support and ask if it’s okay to remove one or all of the tubes and then power it on. This way you could remove one tube at a time and see if the hum goes away -- and you know it’s the tubes. (I should mention power off and unplug the unit each time before you remove any tube).

Not a good idea to remove tubes leaving a socket or sockets empty, and then power on. Unless of course ARC directly gives their verbal consent.  Also, even if you could get away with it without damaging the power supply or downstream equipment, it would be difficult to assign blame for the hum, because you've removed the pathway (to the speakers) by which you detected the hum in the first place. So you'd likely get a false positive result.

Something about the way the OP described the "humming" makes me think it is not a 60Hz or 120Hz noise but instead a mix of frequencies, which you can get with a microphonic tube or a tube picking up RF.  Also, those 6922s can do that.

Thanks for all the suggestions so far.
Tried changing the position of the phase and neutral (I live in Sweden where we have 230 V. That is, rotate the plug in the socket. Now it was completely silent, tried to change back and the noise occurred again. Changed again and dead silent again. The problem is fixed .
Many thanks for all the suggestions.
Regards
Niklas